Manitowoc I0320 Especificaciones descargar pdf (Pagina 181)

Part Number STH025 2/14 181

ICE MACHINE DOES NOT CYCLE INTO HARVEST

Will not harvest symptoms

• Low ice production

• Thick ice in bin

• Large sheet of ice on evaporator

• Harvest cycle doesn’t start

• Freeze cycles are longer than published cycle

times

If ice is on the evaporator initiate a manual harvest

cycle by performing the following keystrokes.

• Press Menu

• Scroll down to Service and press right arrow

• Scroll down to Manual Harvest and press right

arrow - A new freeze cycle will start after the

manual harvest cycle is complete.

NOTE: Ice must be off the evaporator before starting

the procedure.

1. Disconnect the ice thickness probe from the

control board, then reboot the control board by

disconnecting and reconnecting line voltage to the

ice machine.

2. Wait six minutes into the freeze cycle (timing

starts when the water pump energizes).

• Ice Machine cycles into harvest normally - Perform

steps 1 & 2 on

page 179 to test ice thickness

probe and control board.

• Ice machine will not cycle into harvest - Replace

control board.

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 271 272

Sin comentarios

Manitowoc I0320 Especificaciones Pagina 181