Manitowoc S model Especificaciones Pagina 218

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 292
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 217
218 Part Number 80-1230-9 10/10
Evaporator Disassembly
1. Remove spline hub and key stock. Sand shaft
smooth where setscrew contacted shaft.
2. Remove evaporator top cap and grease from top
of evaporator.
3. Remove top snap ring (big clip). (QF2300 Only -
also remove spring shim.)
4. Drive auger shaft out through top of evaporator by
placing wooden 2 x 4 on floor and tap auger shaft
on 2 x 4.
5. Remove run-out collar (remove from bottom or
run-out collar will be on the auger).
6. Remove bottom shaft seal.
7. Remove lower bearing snap ring. (QF2300 Only -
also remove bearing shim.)
8. Drive out bottom bearing (QF2300 Only - also
drive out second bearing shim) with bearing
removal tool (top to bottom).
9. Remove water seal snap ring.
10. Remove water seal (top to bottom).
11. Remove snap ring from top of auger.
12. Remove top bearing with a bearing puller.
13. Remove top seal.
SPLINE HUB AND KEY STOCK
Vista de pagina 217
1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 291 292

Comentarios a estos manuales

Sin comentarios