Manitowoc MII 150 Guía para resolver problemas descargar pdf (Pagina 27)

Installation and Service Manual

HOW TO DISASSEMBLE FOR CLEANING OR MAINTENANCE

NOTE: Sanitize the ice dispenser at Initial Start-UP

in addition to monthly sanitizing. You will need

screwdriver in order to disassemble.

Disassemble parts in the following order:

A. Merchandiser

B. Ice chute

C. Paddle wheel pin

D. Agitator

E. Paddle wheel

F. Bin liner & Support

G. Paddle wheel Area

Accessing a Dispenser Bin Top Mounted with a Mani-

towoc Cuber:

1. Remove the front panel of the ice machine.

2. Remove the ice deflection baffle. This will give you

access to the dispenser bin.

Accessing a Dispenser Bin that is Top Mounted with

a Manitowoc Cuber and Large Extended Merchandiser

in front of the Cuber:

1. Access to the bin is possible through the strip lids on

the side of the Dispenser.

Disassembling the Dispenser Parts for Bin Cleaning:

1. Remove the front panel of the Manitowoc ice maker.

2. If the Manitowoc ice maker is operating, wait for the

sheet of ice to fall into the dispenser bin.

When the ice sheet falls into the dispenser bin, immediately

place toggle switch of the ice machine to the “OFF” position.

If the Manitowoc ice maker is NOT operating, place the

toggle switch of the ice machine to the “OFF” position.

3. On models without a top mounted cuber, remove the

plastic lit from the top of the dispenser.

4. Remove all ice from the dispenser.

5. Disconnect electrical power to the dispenser.

6. On the MII-302 dispenser only, remove the strip lids

off the top left and top right of the dispenser bin.

7. For the MII-302 dispenser only, there is a left bin and

a right bin. Clean and sanitize one bin, then follow

the same procedures on the second bin.

USER MAINTENANCE

PREVENTATIVE MAINTENANCE

Preventative maintenance is a vital part of keeping your MII dispenser in top condition. Following the guidelines

below will assist you in continued trouble free operation of your unit.

1. Conduct daily maintenance of the machine.

2. Perform monthly maintenance of the machine.

3. Perform periodic maintenance and sanitizing of bev-

erage system.

4. Do not overfill the dispenser bin with ice.

5. Do not allow the dispenser to sit for prolonged peri-

ods of non use with ice in the bin.

6. Most ice dispenser service problems are caused by

low usage of the ice dispenser.

7. Do not allow ice to remain in the bin more than a day

in order to prevent ice from freezing together and/or

stagnant ice.

Possible excess ice storage reasons:

• Storage capacity exceeds daily requirements.

• Low demand during the off season.

• Dispenser oversized with future growth in mind.

Lower ice storage to meet one day’s needs. If you manu-

ally fill ice, fill only with the appropriate amount of ice. Fill

the dispenser with fresh ice each morning. Do not fill the

dispenser at night just before shut down. Ice cubes can

freeze together if not dispensed.

Contact MBE at 1-800-367-4233 for more information

about our ProActive Maintenance Program.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 47 48

Comentarios a estos manuales

Sin comentarios

Manitowoc MII 150 Guía para resolver problemas Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas productoras de hielo Manitowoc MII 150