Manitowoc I0500 Especificaciones descargar pdf (Pagina 225)

Part Number STH025 02/12 225

Charts

Cycle Times/24-Hour Ice Production/

Refrigerant Pressure Charts

These charts are used as guidelines to verify correct

ice machine operation.

Accurate collection of data is essential to obtain the

correct diagnosis.

• Production and cycle times are for dice cube - Half

dice cube cycle times can be 2 - 3 minutes faster,

depending on model and ambient temperature.

• Regular cube production derate is 7%.

• Ice production checks that are within 10% of the

chart are considered normal. This is due to

variances in water and air temperature. Actual

temperatures will seldom match the chart exactly.

• Refer to “Symptom #2 - Operational Analysis

Table” page 123 for the list of data that must be

collected for refrigeration diagnostics. This list

includes: before beginning service, ice production

check, installation/visual inspection, water system

checklist, ice formation pattern, safety limits,

comparing evaporator inlet/outlet temperatures,

discharge and suction pressure analysis.

• Zero out manifold gauge set before obtaining

pressure readings to avoid misdiagnosis.

• Discharge and suction pressure are highest at the

beginning of the cycle. Suction pressure will drop

throughout the cycle. Verify the pressures are

within the range indicated.

• Record beginning of freeze cycle suction pressure

one minute after water pump energizes.

• 50Hz dice and half dice production derate is 12%.

• 50Hz regular cube total production derate is 14%.

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 269 270

Sin comentarios

Manitowoc I0500 Especificaciones Pagina 225