Manitowoc MULTIPLEX 11M Especificaciones descargar pdf (Pagina 143)

Part Number STH12 9/10 143

J-17 CALIBRATION BUTTON AND LIGHT

If microprocessor does not go into calibration, remove

connector at J-17. With jumper wire, jump 1st and 2nd

pins on left 3 times in less than 3 seconds. Replace

connector. Calibration light should be on

(microprocessor will be in the calibration mode). White

& white = calibration button. Red & black = calibration

light. If CAL light does not come on, LED is burned out

— replace keyboard.

SECONDARY BOARD PIN IDENTIFICATION

J-1 = Valve 2 Flavor 1

J-2 = Valve 2 Flavor 2

J-3 = Valve 4 Flavor 1

J-4 = Valve 4 Flavor 2

Use a jumper wire to make these connections to

determine if timer is functioning properly.

1. Jump pin 2 or 3 on J-19 and pin 7 or 9 on J-16.

Then jump pin 1 on J-16 to pin 7 or 9 on J-16.

Appropriate valve should energize as long as pins

are jumped.

2. Jump pin 2 or 3 on J-19 and pin 7 or 9 on J-16.

Then jump pin 12 on J-16 to pin 7 or 9 on J-16.

Appropriate valve should pour Extra Large.

3. Jump pin 2 or 3 on J-19 and pin 7 or 9 on J-16.

Then jump pin 2 on J-16 to pin 7 or 9 on J-16.

Appropriate valve should pour Large.

4. Jump pin 2 or 3 on J-19 to pin 7 or 9 on J-16.

Then jump pin 3 on J-16 to pin 7 or 9 on J-16.

Appropriate valve should pour Medium.

5. Jump pin 2 or 3 on J-19 to pin 7 or 9 on J-16.

Then jump pin 4 on J-16 to pin 7 or 9 on J-16.

Appropriate valve should pour Small.

6. Jump pin 2 or 3 on J-19 to pin 5 on J-19. Then

jump pin 5 on J-19 to pin 7 or 9 on J-16.

Appropriate valve should pour Kid Size.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 235 236

Sin comentarios

Manitowoc MULTIPLEX 11M Especificaciones Pagina 143