Manitowoc NEO UD0310AE Especificaciones descargar pdf (Pagina 114)

114 Part Number STH042 3/14

System Contamination Cleanup

This section describes the basic requirements for

restoring contaminated systems to reliable service.

DETERMINING SEVERITY OF CONTAMINATION

System contamination is generally caused by either

moisture or residue from compressor burnout entering

the refrigeration system.

Inspection of the refrigerant usually provides the first

indication of system contamination. Obvious moisture

or an acrid odor in the refrigerant indicates

contamination.

If either condition is found, or if contamination is

suspected, use a Total Test Kit from Totaline or a

similar diagnostic tool. These devices sample

refrigerant, eliminating the need to take an oil sample.

Follow the manufacturer’s directions.

If a refrigerant test kit indicates harmful levels of

contamination, or if a test kit is not available, inspect

the compressor oil.

1. Remove the refrigerant charge from the ice

machine.

2. Remove the compressor from the system.

3. Check the odor and appearance of the oil.

4. Inspect open suction and discharge lines at the

compressor for burnout deposits.

5. If no signs of contamination are present, perform

an acid oil test to determine the type of cleanup

required.

Important

Manitowoc Ice assumes no responsibility for the

use of contaminated refrigerant. Damage

resulting from the use of contaminated refrigerant

is the sole responsibility of the servicing company.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 135 136

Sin comentarios

Manitowoc NEO UD0310AE Especificaciones Pagina 114